Set the conditions for the [Fold & Staple].
The displayed screens and selectable setting items vary depending on the optional devices mounted on this system.
[Valid Object] cannot be changed in [All Sheets] because it is fixed.
Setting item | Description | ||
---|---|---|---|
[Trim or Non Trim] | [Trimming] | Trims the fore edge. | |
[Non Trimming] | Does not trim the fore edge. | ||
[Valid Object] | [Valid Object] cannot be changed in [All Sheets] because it is fixed. | ||
[Function OFF] | Turns the function off while maintaining the set information. |
Setting item | Description | ||
---|---|---|---|
[Staple] | [2 Positions] | Staples at 2 positions. | |
[4 positions] | Staples at 4 positions. | ||
[Spine Corner] | [ON] | Forms the spine corner. | |
[OFF] | Does not form the spine corner. | ||
[Crease] | [ON] | Only creases the covers for Fold & Staple. | |
[OFF] | Does not crease. | ||
[(1)Fore-edgeTrim] | [ON] | Trims the fore edge. | |
[OFF] | Does not trim the fore edge. | ||
[(2)2-Side Slit] | [ON] | Slits both edges of the paper. [Slitting] and [Offset against Cover] are available. | |
[OFF] | Does not slit both edges of the paper. | ||
[Valid Object] | [Valid Object] cannot be changed in [All Sheets] because it is fixed. | ||
[Function OFF] | Turns the function off while maintaining the set information. |
Setting item | Description | |
---|---|---|
[Fold & Staple] | [ON] | Folds and staples paper. |
[OFF] | Does not fold and staple paper. | |
[Valid Object] | [Valid Object] cannot be changed in [All Sheets] because it is fixed. | |
[Function OFF] | Turns the function off while maintaining the set information. |
When Saddle Stitcher SD-513 is mounted, form the spine corner for Fold & Staple paper.
The setting screen is displayed.
First, set to [Normal]. If the result is not desirable, change the strength.
When Saddle Stitcher SD-513 is mounted, set [Slitting] and [Offset against Cover] for 2-Side Slit.
The setting screen is displayed.
Range: 8.0 mm to 26.0 mm
Pressing [,]/[+] increases or decreases the numeric value in steps of 0.1 mm.
Use [+ / -] to set the plus or minus of the numeric value.
When the slitting amount is different between [(1)] and [(2)] by 10.0 mm or more, its value cannot be entered.
Range: -1.0 mm to 1.0 mm
Pressing [,]/[+] increases or decreases the numeric value in steps of 0.1 mm.