Configure settings to slit both edges of paper. The slitting amount can also be set.
You can also select a sheet to apply the setting to.
Setting item | Description | |
---|---|---|
[Valid Object] | [All Sheets] | Trims both edges of all sheets. |
[Cover Only] | Trims both edges of only the cover. | |
[Slitting] | [(1)] | Sets the slitting amount at the top of the paper. Range: 8.0 mm to 26.0 mm It is not possible to set the value above 10.0 mm as the trimming amount difference from [(2)]. |
[(2)] | Sets the slitting amount at the bottom of paper. Range: 8.0 mm to 26.0 mm When the trimming amount is different from [(1)] by 10.0 mm or more, this setting is not available. | |
[Offset against Cover] | Sets the slitting amount of the body for the cover. Range: -1.0 mm to 1.0 mm (0.1 mm notches) | |
Keypad | Enter the slitting amount. | |
[,] / [+] | Increases or decreases the numeric value in increments of 0.1 mm. | |
[+ / -] | Sets the plus or minus of the numeric value. |