JOB LIST | [Multi Tri-Fold]

[Multi Tri-Fold]

Configure the setting to apply Multi Tri-Fold to the paper.

The displayed screens and selectable setting items vary depending on the optional devices mounted on this system.

[Valid Object] cannot be changed in [All Sheets] because it is fixed.

NOTICE

Finisher FS-532 with SaddleStitcher SD-506 or Saddle Stitcher SD-510 mounted is required to set the [Multi Tri-Fold].

NOTICE

Saddle Stitcher SD-513 with Creaser Unit CR-101 mounted is required to set the [Crease].
Saddle Stitcher SD-513 with Trimmer Unit TU-503 mounted is required to set the [2-Side Slitting].

NOTICE

Only 1 sheet is folded for creasing. It is not folded multiply.
A misalignment may occur between the fold position and crease position depending on the paper weight. In such a case, adjust the crease position to suit the fold position. For details, refer to [Saddle Stitcher Adjustment] (Saddle Stitcher SD-513).

NOTICE

Only 1 sheet is folded for slitting. It is not folded multiply.
If [2-Side Slitting] is combined with Tri-Fold, wrinkles may occur depending on the paper type.
If [2-Side Slitting] is combined with Tri-Fold and [Crease], the part near wrinkles may be broken. If wrinkles occur in either case, reduce the slitting amount, because wrinkles are easily formed when the slitting amount is 20 mm / 0.787" or more.

Reference

Setting item		Description
[Multi Tri-Fold]	[ON]	Multi tri-folds paper.
[Multi Tri-Fold]	[OFF]	Does not multi tri-fold paper.
[Valid Object]		[Valid Object] cannot be changed in [All Sheets] because it is fixed.
[Function OFF]		Turns the function off while maintaining the set information.

Setting item		Description
[Crease]	[ON]	Creases only the covers for Multi Tri-Fold.
[Crease]	[OFF]	Does not crease.
[2-Side Slitting]	[ON]	Slits both edges of the paper. [Slitting] and [Offset against Cover] are available.
[2-Side Slitting]	[OFF]	Does not slit both edges of the paper.
[Valid Object]		[Valid Object] cannot be changed in [All Sheets] because it is fixed.
[Function OFF]		Turns the function off while maintaining the set information.

Set [Slitting] and [Offset against Cover] for 2-Side Slit.

Press [ON] in [2-Side Slitting].

The setting screen is displayed.

Select [(1)] or [(2)] of [Slitting], and use the on-screen keypad to enter the slitting amount.

Use [+ / -] to set the plus or minus of the numeric value.
When the slitting amount is different between [(1)] and [(2)] by 10.0 mm or more, its value cannot be entered.

Select [Offset against Cover], and use the on-screen keypad to enter the slitting amount of the body for the cover.

Press [OK].