Home CopyHow to Make a Basic Copy

How to Make a Basic Copy

Follow the procedure below to make a basic copy.

  • The following describes the basic procedure. It is not always applicable to the operations of set copy conditions. When using a specific function, be sure to follow the procedure described in each section.

  1. Position the original.

  2. Press the [COPY] tab to display the [COPY] screen.

    The [MACHINE] screen shows up first at the default setting. To display the [COPY] screen, press the [COPY] tab on the [MACHINE] screen.

    • [Default Screen Setting] can be set to the [Hold Job] screen of the [JOB LIST] screen or the [Reserved Job] screen of the [JOB LIST] screen. To display the [COPY] screen, press the [COPY] tab in both cases.

  3. Set copy conditions as desired.

    The following settings are available from the [COPY] screen.

  4. Enter the desired print quantity from the keypad on the control panel.

    Entered quantity is displayed.

  5. Press Start on the control panel.

    • In order to start copying, make sure to display the [COPY] screen. If you press Start with any other screen displayed, you cannot start copy operations.

    • If you print from the [Hold Job] screen or the [HDD RECALL] screen, the [COPY] screen does not have to be returned.

    • When scanning the original for the job is started, a dialog is displayed on the [COPY] screen.

  6. Press either [Yes] or [No] on the dialog.

    • To return to the [COPY] screen, press [Yes].

    • You are now ready to set reserve job.

    • To return to the screen set in [Default Screen Setting], press [No].

    The count and set quantities are displayed at the upper right corner of both screens.

    The current job is displayed in the job list in the [Reserved Job] screen of the [JOB LIST] screen.