E-mail Initial Setting

Configure the default settings of E-mail.

  • Configure this setting to use the CS Remote Care. For details, contact your service representative.

  1. Follow the procedure on Displaying the [Administrator Setting Menu] Screen to display the Administrator Setting Menu screen.

  2. Press Network Setting on the Administrator Setting Menu screen, and then press E-Mail Initial Setting.

    The E-mail Initial Setting screen is displayed.

  3. Make a setting for each item.

    • supplementary explanationUse the touch panel keypad or the keypad on the control panel to enter numeric values. Press Set to highlight the next area for entry.

    • supplementary explanationWhen the DNS server is used, the host name can be entered in the field for mail server (Full path, up to 128 one-byte characters). For more information about how to enter characters, refer to Inputting Characters.

    • supplementary explanationWhen using the Enhanced Security mode, only the IP address can be entered.

  4. When required entries are completed, run a transceiving test.

    • supplementary explanationPressing Test will display the confirmation dialog. Press Yes to check that the setting has been made properly.

  5. Press OK to complete the setting.

    • supplementary explanationTo cancel the change, press Cancel. In either case, the screen returns to the Network Setting Menu screen.