In order to use Color Centro, you must first perform the setup.
The setup refers to a series of preparatory procedures, from connecting the image controller with the computer to installing Color Centro on your computer.
Connect the image controller and the computer to the network.
Check that the computer is connected to the network.
Check the image controller's IP address and the port number in the JSP Setting.
supplementary explanationFor details, refer to Settings of this machine.
Install Color Centro.
supplementary explanationFor details, refer to Installation of Color Centro.
Installation or uninstallation requires the administrator privilege.
Close all running applications before installation or uninstallation.
When you execute calibration by using a colorimeter, install the driver of the colorimeter. After installing, execute the measurement test and check that there is no problem with the connection.
There are two types of the Color Centro calibration functions: Regular and advanced. Advanced calibration has 2 options: Exact Color calibration and G7 calibration. By default, Exact Color is selected. If you need to change the setting to G7 calibration, please contact your service representative.
For details about the interface, refer to Operating environment.
For details about the network settings and the IP address of the image controller, refer to [NIC Settings].
For details about advanced calibration, refer to Overview of Calibration.