This section describes how to adjust the density balance controlled on the control panel.
Density Balance Adjustment allows to create density balance adjustment data for correcting the non-uniformity of density in the crosswise direction.
Two methods are available to register new density balance adjustment data in the crosswise direction as shown below.
How to register colorimetric data for automatic adjustment->Registering Colorimetric Data for Automatic Adjustment
How to enter the density balance adjustment value for manual adjustment ->Entering New Density Balance Adjustment Data for Manual Adjustment
The "crosswise direction" is the direction that intersects with the paper feed direction at right angles.
If necessary, you can manually adjust existing data, or duplicate/delete the adjustment value as well as set enable or disable the adjustment value.