Adjust 2 position staple pitch and corner staple positions in the staple finisher.
Objects of Adjustment: 2 Position Pitch (120 mm), 2 Position Pitch (140 mm), 2 Position Pitch (165 mm), Rear Diagonal, Rear Parallel, Front Parallel
Press [Adjustment] on the [MACHINE] screen to display the [Adjustment Menu] screen.
Press [Finisher Adjustment], [Staple Finisher Adjustment], [Staple Finisher(Main) Adj.], and [Staple Position Adjustment] in sequence.
Select [2 Position Pitch(120mm)], [2 Position Pitch(140mm)], [2 Position Pitch(165mm)], [Rear Diagonal], [Rear Parallel], or [Front Parallel] to adjust the staple position.
Press [Print Mode].
Load the desired paper into a tray, then select that tray.
For [Output Setting], [Staple] is automatically selected, and the staple position selected in step 3 is selected.
Press Start on the control panel.
A sample pattern will be output.
Check the staple positions (a) of the printed paper.
When [2 Position Pitch(120mm)], [2 Position Pitch(140mm)], or [2 Position Pitch(165mm)] is selected:
Allowance for [2 Position Pitch(120mm)]: a = 120 mm ± 3 mm
Allowance for [2 Position Pitch(140mm)]: a = 140 mm ± 3 mm
Allowance for [2 Position Pitch(165mm)]: a = 165 mm ± 3 mm
When [Rear Diagonal] is selected:
Allowance : a = 15.2 mm ± 3 mm
When [Rear Parallel] is selected:
Allowance: a = 19.6 mm ± 2 mm
When [Front Parallel] is selected:
Allowance: a = 6.4 mm ± 3 mm
Press [Exit PrintMode] to return to the [Staple Position Adj.] screen.
If any adjustment is required, use the touch panel keypad to enter the set value.
Adjustment range for [2 Position Pitch (120 mm)], [2 Position Pitch (140 mm)], and [2 Position Pitch (165 mm)]:
-5 ([Narrow]) to +5 ([Wide]) (1 step = 1.0 mm)
Adjustment range for [Rear Diagonal]:
-5 ([Narrow]) to +5 ([Wide]) (1 step = 1.0 mm)
Adjustment range for [Rear Parallel] and [Front Parallel]:
-3 ([Narrow]) to +3 ([Wide]) (1 step = 1.0 mm)
Use [+/-] to specify the value to be positive or negative.
Press [Set] to change the setting with the Current Data.
Repeat steps 3 to 10 until the desired result is obtained.
Press [Return].
The screen returns to the [Staple Finisher(Main) Adjustment Menu] screen.