Adjust the distance from the edge of the printed paper to the center of punch holes in Punch Kit PK-522 mounted on Finisher FS-532.
Objects of Adjustment: Offset for All Size, A3 , A4 , A4 , SRA4 , A5 , B4 , B5 , 8K , 16K , 16K , 8.5 14 , 8.5 11 , 8.5 11 , 12 18 , 8.12 13.2 , 11 17 , 8.5 13 , 8.25 13 , 8 13 , 5.5 8.5 , 9 11 , B5
If a numeric value is specified for [Offset for All Size], it is applied to all paper sizes. With a specific paper size selected,the set value becomes the sum of the entered value and the value previously specified for [Offset for All Size].
Press [Adjustment] on the [MACHINE] screen to display the [Adjustment Menu] screen.
Press [Finisher Adjustment], [Staple Finisher Adjustment], [Staple Finisher(Punch) Adj.], and [Horizontal Position Adj.(FD)] in sequence.
Select the size to be adjusted using [] or [].
Press [Print Mode].
Load the paper size selected in step 3, then select that tray key.
For [Output Setting], [Punch] is automatically selected.
Press Start on the control panel.
A sample pattern will be output.
Measure the distance (a) from the edge of the printed paper to the center of punch holes.
Allowance for 2-hole punch: a = 12 mm ± 3 mm
Press [Exit PrintMode] to return to the [Horizontal Position Adj.(FD)] screen.
If any adjustment is required, use the touch panel keypad to enter the set value.
Adjustment Range: ([Far]) -50 to +50 ([Close]) (1 step = 0.1 mm)
Press [+/-] to specify the value to be positive or negative.
Press [Set] to change the setting with the Current Data.
Repeat steps 4 to 10 until the desired result is obtained.
Press [Return].
The screen returns to the [Staple Finisher(Punch) Adjustment Menu] screen.