Adjust the alignment plate width of the stacker that aligns sheets in the paper feed direction in staple finisher.
Objects of Adjustment: Offset for All Size, A4 , B5 , A5 , 8.5 11 , 16K , 9 11 , 5.5 8.5 , Custom (148 to 230 mm)
If a numeric value is specified for [Offset for All Size], it is applied to all paper sizes. With a specific paper size selected,the set value becomes the sum of the entered value and the value previously specified for [Offset for All Size].
Press [Adjustment] on the [MACHINE] screen to display the [Adjustment Menu] screen.
Press [Finisher Adjustment], [Staple Finisher Adjustment], [Staple Finisher(Main) Adj.], and [FD Alignment Plate Adj.] in sequence.
Select the size to be adjusted.
Press [Print Mode].
Load the paper size selected in step 3, then select that tray.
Press Start on the control panel.
A sample pattern will be output.
Check the misalignment (a) in paper feed direction of printed paper.
Allowance for misalignment (a): 1.0 mm or less when binding 2 to 15 sheets, 1.5 mm or less when binding 16 to 100 sheets
Check sheets for any paper skew. Skew occurs if insertion is too deep.
Press [Exit PrintMode] to return to the [FD Alignment Plate Adj.] screen.
If any adjustment is required, use the touch panel keypad to enter the set value.
Adjustment Range: -50 ([Wide]) to +50 ([Narrow]) (1 step = 0.1 mm)
Use [+/-] to specify the value to be positive or negative.
Press [Set] to change the setting with the Current Data.
Repeat steps 4 to 10 until the desired result is obtained.
Press [Return].
The screen returns to the [Staple Finisher(Main) Adjustment Menu] screen.