If printed paper is misaligned in the paper feed direction on the stacker tray of Large Capacity Stacker LS-506, adjust the position of the stopper to reduce misalignment and skew in printed paper.
Objects of Adjustment: Stacker No. 1, Stacker No. 2
Press [Adjustment] on the [MACHINE] screen to display the [Adjustment Menu] screen.
Press [Finisher Adjustment], [Stacker Adjustment], and [Paper Length Adjustment] in sequence.
If two units of Large Capacity Stacker LS-506 are connected, select either [Stacker No.1] or [Stacker No.2].
Press [Print Mode].
Load the desired paper into a tray, then select that tray.
Press Start on the control panel.
A sample pattern will be output.
Check that no printed paper is misaligned or skewed.
If misaligned If skewed
If any adjustment is required, press [Exit PrintMode] to return to the [Paper Length Adjustment] screen.
Use the touch panel keypad to enter the set value.
Use [+/-] to specify the value to be positive or negative.
Press [Set] to change the current value.
Adjustment Range: -20 ([To reduce dispersion]) to +20 ([To reduce distortion]) (1 step = 0.1 mm)
Repeat steps 4 to 9 until the desired result is obtained.
Press [Return].
The screen returns to the [Stacker Adjustment Menu] screen.