If the punch position is not parallel to the paper edge for output, control paper curling and wrinkling by adjusting the paper loop of the registration roller in Punch Kit PK-522 mounted on Finisher FS-532.
Press [Adjustment] on the [MACHINE] screen to display the [Adjustment Menu] screen.
Press [Finisher Adjustment], [Staple Finisher Adjustment], [Staple Finisher(Punch) Adj.], and [Registration Adjustment] in sequence.
Press [Print Mode].
Load the desired paper into a tray, then select that tray.
For [Output Setting], [Punch] is automatically selected.
Press Start on the control panel.
A sample pattern will be output.
Check if the punch holes are skew on the printed paper.
Press [Exit PrintMode] to return to the [Registration Adjustment] screen.
If any adjustment is required, use the touch panel keypad to enter the set value.
Adjustment Range: -50 ([Short]) to +50 ([Long]) (1 step = 0.1 mm)
Press [+/-] to specify the value to be positive or negative.
Press [Set] to change the setting with the Current Data.
Repeat steps 3 to 9 until the desired result is obtained.
Press [Return].
The screen returns to the [Staple Finisher(Punch) Adjustment Menu] screen.