[Calibration] Order
Setting Procedure
This section describes how to carry out calibration using a colorimeter in Color Centro. The required time period is approximately 10 minutes.
Step 1
Set [Use Color Density Control] to [OFF]. For details, refer to [Basic Setting].
If [Periodical Adj. Execution] is set to [ON] on this system, calibration data is automatically created, so it is not possible to carry out calibration using the colorimeter in Color Centro.
Step 2
Confirm the calibration status. For details, refer to [Information] - [Check the Status].
Step 3
Set a colorimeter used for calibration. For details, refer to [Settings].
Step 4
Set the paper type and screen. For details, refer to Setting Procedure (Creating Correction Data).
Step 5
Carry out calibration. For details, refer to [Calibration].
Step 6
Measure the calibration accuracy. For details, refer to Setting Procedure (Performing [Accuracy Measurement]).
Step 7
Carry out advanced calibration (Exact Color or G7 Calibration) as needed. For details, refer to [Exact Color] or [G7 Calibration].
Step 8
Reset calibration data as needed. For details, refer to Setting Procedure (Initializing Calibration Data).
in the upper-right of a page, it turns into 
and is registered as a bookmark.