If a Meandering Has Occurred
A meandering may result in the edge of media being damaged or images being out of alignment.
If a meandering occurs, check the following:
The tension applied on the media is correct.
The media or other parts (such as guides on the roller) are set in the right position
The conveyer section is clean of glue.
Follow the procedures below to solve the problem:
STEP 1: Checking the Media Tension
Check if the tension setting of the media has been made properly.
For details, refer to Setting the tension according to the paper type and thickness (weight).
STEP 2: Checking the Position of the Media and Parts
Check if the media or other parts set in the right position.
For details, refer to Adjusting the Positions of the Media and Parts.
STEP 3: Cleaning the Glue Sticking on the Parts
Clean the media guide and restriction guide in the leading section if it is dirty with glue.
For details, refer to Cleaning the Leading Section.
STEP 4: Adjusting the Aligning Roller
If the error persists after the procedure mentioned above is performed, adjust the aligning roller.
For details, refer to Adjusting the Aligning Roller.
STEP 5: Changing the Media Tension
If the error persists after the procedure mentioned above is performed, raise the tension by one level.
For details, refer to Changing the Media Tension.