Changing the Media Tension
If the jam code J-3105 is displayed repeatedly, lower the tension by one level following the table below.
For details about changing the media tension, refer to Setting the tension according to the paper type and thickness (weight).
Before changing the media tension, perform the following: For details, refer to The jam code J-3105 is displayed.
Check the media tension
Check the position of the media and parts
Clean glue sticking on the parts
Level | Position of the Tension Roller 2 | Aligning Roller | Position of the Tension Roller 4 | Air Level of the Paper Feed Loop Fan | |
|---|---|---|---|---|---|
Lower the tension
Raise the tension | 1 | Bottom | Rotate | Bottom | Weak |
2 | Bottom | Rotate | Bottom | Strong | |
3 | Top | Rotate | Bottom | Weak | |
4 | Top | Rotate | Bottom | Strong | |
5 | Top | Fix | Bottom | Weak | |
6 | Top | Fix | Bottom | Strong | |
7 | Top | Fix | Top | Strong |
Level 7 is only used when paper width is 250 mm. For details about the media tension setting, refer to Setting the tension according to the paper type and thickness (weight).