Pressing JOG on the control panel does not enable the solo inching operation.
If the solo inching operation is not enabled after JOG on the control panel of Roll Winder RW-101/Roll Winder RW-201 is pressed, check the following:
Checkpoint | Remedy |
|---|---|
READY on the control panel is not pressed. | Press READY on the control panel, and then press JOG. When READY is pressed, the ready alarm starts. Press JOG within five seconds after the alarm ends. |
[Error] is indicated on the touch panel of Roll Winder RW-201. | [-] While Error is indicated, pressing READY on the control panel does not work. After checking and clearing the error, press EMG.RESET on the control panel. |
[Unwinder Online]/[Rewinder Online] is displayed on the touch panel of Roll Winder RW-201. | The solo inching operation is available only when Roll Winder RW-101/Roll Winder RW-201 is offline. |
The loop on Roll Winder RW-101/Roll Winder RW-201 is in the lowest position. | The loop detection sensor is activated. Wait until the form of the loop becomes stable. Or convey the media and modify the form of the loop manually. |
The loop on Roll Winder RW-201 is in the highest position. | The loop detection sensor is activated. Wait until the form of the loop becomes stable. Or loosen the media and modify the form of the loop manually. |
The media tension on Roll Winder RW-201 is not turned on. | Press REWIND MOTOR ON on the control panel of Roll Winder RW-201 to turn on the media tension. |