Adjust the gutter slit position. Even if the numeric value is changed, the gutter width remains unchanged.
The following option is required to use this function.
If a trimmer profile is set, you can only select the same paper size as the size set in the trimmer profile.
Only when the trimmer profile is set, trimming can be set in [Trim] of [Output Setting].
A sample is output.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
(-) To move the slit position in the front side, (+) To move the slit position to the rear side
[Adj. Range:-30~+30 1step = 0.1mm]
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
(-) To move the slit position to the rear side, (+) To move the slit position to the front side
[Adj. Range:-30~+30 1step = 0.1mm]