Adjust the perforation position in the feed direction.
The following option is required to use this function.
If a trimmer profile is set, you can only select the same paper size as the size set in the trimmer profile.
Only when the trimmer profile is set, trimming can be set in [Trim] of [Output Setting].
A sample is output.
Adjust this when shifting occurs at the second position before the perforation in the feed direction with [Multiple Cutting Mode].
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
(-) To move the perforation position to the front side, (+) To move the perforation position to the rear side
[Adj. Range:-50~+50 1step = 0.1mm]
Adjust this when shifting occurs at the second position behind the perforation in the feed direction with [Multiple Cutting Mode].
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
(-) To move the perforation position to the rear side, (+) To move the perforation position to the front side
[Adj. Range:-50~+50 1step = 0.1mm]
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
(-) To move the jump position to the lead side (+) To move the jump position to the rear edge
[Adj. Range:-50~+50 1step = 0.1mm]