Adjust the trim position in the crosswise direction.
Select what numbered trim position is adjusted.
If a trimmer profile is set, you can only select the same paper size as the size set in the trimmer profile.
Only when the trimmer profile is set, trimming can be set in [Trim] of [Output Setting].
A sample is output.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
(-) To move the trimming position to the lead edge, (+) To move the trimming position to the rear edge
[Adj. Range:-50~+50 1step = 0.1mm]