[Vertical Position Adj.(CD)]
Overview
Adjust the distance between the center of the punched output paper and the center of the punch holes, and arrange the finishing.
Perform this function when the punch position is misaligned.
Setting Procedure
1
Press the selection key of the paper size to adjust.
2
Press [Print Mode].
3
Load the paper of the size selected in step 1 into any paper tray, and select that paper tray.
[Output Setting] is automatically set to [Punch].
4
Press Start on the Control panel.
A sample is output.
5
Check distance "a" from the center of the output paper to the center of punch holes.
Standard value: a = 0 mm -1 mm to +1 mm
6
If any adjustments are required, press [Exit PrintMode] to return to the setting screen.
7
Use the on-screen keypad to enter the numeric value.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
Punch position at paper edge: [-] Forward [+] Backward
[Adj. Range:-50~+50 1step = 0.1mm]
8
Repeat steps 2 to 7 until the desired result is obtained.
Was this information useful?
Thank you.
in the upper-right of a page, it turns into 
and is registered as a bookmark.