[2-Side Slit Finishing Adj.]
Overview
Adjust the trimming speed on the top and bottom sides of the Saddle Stitcher SD-513.
You can reduce the slit part for skewing or napping.
NOTICE
The following option is required to use this function.
- Saddle Stitcher SD-513 with Trimmer Unit TU-503 mounted
Setting Procedure
1
Select [61g/m2 or Less] or [62g/m2 or More].
2
Press [Print Mode].
3
Load A3 w or 11 e 17 w paper into any paper tray, and select that paper tray.
4
Press Start on the Control panel.
A sample is output.
5
Check the slit part for skewing or napping.
6
If any adjustments are required, press [Exit PrintMode] to return to the setting screen.
7
Use the on-screen keypad to enter the numeric value.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
[Adj. Range:-4~+4 1step = 5mm/sec]
To reduce napping, slow down the slitting speed. To reduce skewing, increase the slitting speed.
8
Repeat steps 2 to 7 until the desired result is obtained.
in the upper-right of a page, it turns into 
and is registered as a bookmark.