HomeDescription of Setup Buttons

Descriptions of Setup Buttons

Description of Setup Buttons

Line Setting[Scan/Fax]

To display:
  • [Scan/Fax]
    • [Application]
      • [Fax Setting]
        • [Line Setting]

Specify how to send a fax based on the line conditions.

 

Line Setting

To display:
  • [Scan/Fax]
    • [Application]
      • [Fax Setting]
        • [Line Setting]

Specify how to send a fax based on the line conditions.

SettingsDescription
[TX Method]
Change the communication mode based on the line conditions.
  • [Overseas TX]: Select this option to send a fax to areas where communication conditions are poor. Faxes are sent at a lower speed.
  • [ECM]: Generally, faxes are sent while checking that the fax data is free of errors by using ECM (Error Correction Mode). To reduce the time required to send a fax, cancel the setting.
  • [V.34]: Generally, faxes are sent in the Super G3 mode. If it is not possible to send faxes in the Super G3 mode, cancel the setting.
[Check Dest. and Send]
Select this option to use the Check Dest. And Send function.
The fax number specified for fax is checked against the remote fax number (CSI) and the fax is only sent when they match.
[Select Line]
If two lines are used, select the line used to send a fax.
If [No Selection] is selected, either line, whichever is not busy, is used for transmission.

Long Original[Scan/Fax]

To display:
  • [Scan/Fax]
    • [Application]
      • [No. of Originals]
        • [Original Settings]
          • [Long Original]

Select this option when loading a long original that is larger in the feeding direction than the full standard size (11 17 or A3).