Printing on Banner Paper
About printing on banner paper
This machine allows you to load paper of up to 1200 mm (47-1/4 inches) into the Bypass Tray and make prints.
Printable paper
Paper width | Paper length | Paper weight |
|---|---|---|
90 mm to 297 mm 3-9/16 inches to 11-11/16 inches | 457.3 mm to 1200 mm 18 inches to 47-1/4 inches | 127 g/m2 to 210 g/m2 (33-13/16 lb to 55-7/8 lb) Using the printer driver, select the paper type appropriate for the weight of the banner paper to be used.
|
How to print on banner paper
Specify the banner paper size.
1
On the screen of this machine, tap [Utility] - [Banner Printing].
2
Select [Allow], and tap [OK].
3
Check that the system is changed to the banner print job wait state.
When you have finished the above settings, start to print from the PC.
4
In [Original Size] in the [Basic] tab, select [Custom Size].
5
Specify the length and width of the banner paper, and click [OK].
6
Click [Yes] on the screen to check changes.
The [Paper Tray], [Paper Type], and [Print Type] settings are switched. If [Resolution] is set to [1200dpi (Rasterize on Device)], it is switched to [600dpi].
7
Change the setting of [Paper Type] for Bypass Tray according to the weight of print paper.
8
Execute printing.
A message that prompts you to load paper is displayed on the screen of this machine.
9
Load the banner paper into the Bypass Tray.
For information on how to load banner paper into the Bypass Tray, refer to Loading banner papers.
10
When you have loaded banner paper, tap [Complete] to start printing.
Support the ejected banner paper by hand.
To continue printing, execute printing from the computer.
11
Tap [Exit].
A message confirming the end of banner printing is displayed.
12
Tap [Yes].
If there is a queued job, the job is started.
in the upper-right of a page, it turns into 
and is registered as a bookmark.