Connect the media using the workbench of Roll Winder RW-201
Place the end of the media cut on the workbench onto the media conveyed from the main body or vice versa.
Insert the media into the cutter groove of the workbench, hold it with the two supplied magnet bars, and then cut it following with the cutter groove.
After cutting, remove the overlapped part.
Be careful not to cut your hand when cutting the media.
Adhere the joint of the media from the back side with masking tape.
Adhere so that the masking tape protrudes from both ends of the media.
Adhere the joint of the media from the front side with masking tape.
Adhere so that the masking tape protrudes from both ends of the media.
Adhere the joint firmly by rubbing the surface of the masking tape to avoid peeling the media during transport.
Cut the protruded parts of the masking tape from both ends of the joint.
Remove the two supplied magnet bars holding the media.
When the procedures are completed, convey the media. For details, refer to Conveying the media.