Home User MaintenanceCutting the media using the workbench of Roll Winder RW-101

Cutting the media using the workbench of Roll Winder RW-101

This section describes how to cut the media using the workbench of Roll Winder RW-101.

  • Replace the media while the machine is stopped.

  1. Press WEB GRIPPER1 and WEB GRIPPER2 on the control panel of Roll Winder RW-101.

    The media pressing bar 1 and media pressing bar 2 on the workbench of Roll Winder RW-101 are locked to hold the media.

  2. Cut the media following the cutter groove on the workbench.

    • Be careful not to cut your hand when cutting the media.

  3. Press WEB GRIPPER1 on the control panel of Roll Winder RW-101 to unlock the media pressing bar 1.