[IEEE802.1X Authentication Setting]

When using IEEE802.1X authentication, set this option to ON (default: OFF).

[Authentication Status]

Displays the status of IEEE802.1X authentication on this machine.

[Supplicant Setting]

Configure settings to operate this machine as a supplicant (client to be authenticated).

For details on settings, refer to the [Supplicant Setting] settings (shown below).

[Reset Job Settings]

Reset the current setting.

[User ID]

Enter a user ID (using up to 128 single-byte characters).

This user ID is used for all EAP-Type options.

[Password]

Enter a password (using up to 128 single-byte characters).

The password is used for all EAP-Type options other than [EAP-TLS].

[EAP-Type]

Select the EAP authentication method (default: [OFF]).

• [Depend on Server]: The EAP-Type provided by the authentication server will be used for authentication. Configure the supplicant settings as required for this machine according to the EAP-Type provided by the authentication server.

• Do not select [OFF].

[EAP-TTLS]

Configure the EAP-TTLS settings if [EAP-Type] is set to [EAP-TTLS] or [Depend on Server].

• [anonymous]: Enter the user ID used for EAP-TTLS authentication (using up to 128 single-byte characters).

• [Inner Authentication Protocol]: Select an internal authentication protocol for EAP-TTLS.

[Server ID]

To verify CN of the certificate, enter the server ID (using up to 64 single-byte characters).

[Client Certificates]

Select whether to encrypt the authentication information using a certificate for this machine.

This setting can be configured if the following conditions are satisfied:

• The certificate is registered on this machine

• [EAP-TLS], [EAP-TTLS], [PEAP], or [Depend on Server] is selected from [EAP-Type].

[Certificate Verification Level Settings]

To verify the certificate, select items to be verified.

• [Expiration Date]: Confirm whether the certificate is within the validity period (default: ON).

• [CN]: Confirm whether CN (Common Name) of the certificate matches the server address (default: OFF).

• [Chain]: Confirm whether there is a problem in the certificate chain (certificate path) (default: OFF). The chain is validated by referencing the external certificates managed on this machine.

[Network Stop Time]

When specifying the delay time between the start of an authentication process and the end of network communication, set this option to ON (default: OFF).

• [Stop Time]: Enter the delay time (sec.).

If an authentication process does not succeed within the specified time, all network communication will stop. To restart the authentication process after network communication stopped, reboot this machine.