What Is [FTP]?
Overview
Configure this setting when sending scan data using FTP.
The destination can be selected from the list of pre-registered destinations or entered directly. Additional destinations can also be registered.
Tips
- Only 1 FTP destination can be selected. To send data, this destination can also be combined with a destination specified in another sending method.
- It is convenient to pre-register frequently used destinations. For details about how to register a destination, refer to [Scan Address Register].
Tips
- For details about how to enter characters, refer to Entering Text.
Setting Items
Screen access
Touch panel - [SCAN] - [FTP]
Setting item | Description |
|---|---|
Destination key | Displays the registered destinations. Press the key to select a destination. |
Manually enter a destination. When sending a job to an unregistered destination, set this item. | |
Searches for the target destination from the registered destinations. | |
[A to Z] | Displays a list of destinations for which [Reference Name] is registered with alphabetic characters. |
[Others] | Displays a list of destinations for which [Reference Name] is registered with characters such as symbols other than alphabetic characters. |
[Main] | Displays a list of frequently used destinations that are registered in [Main]. |
[All] | Displays all of the registered destinations. |
[+] / [,] | Switches the destinations list page. Up to 12 destinations are displayed on each page. |
[Clear All] | Resets the selected destination. When multiple destinations are selected using certain sending methods, they can be canceled collectively. |
[Register/Edit] | Registers, edits, or deletes a destination. For details, refer to [Register/Edit] (FTP). |
Saves the selected destination, and sets scanning conditions. |
Setting Procedure (Sending by FTP)
1
Press [FTP].
2
Press the registration name in the destination list, and select a destination.
The selected destination is displayed in [List] of the left pane of the screen.
To cancel the selected destination, press the selected registration name again.
3
On the screen shown in step 2, press [Scan Settings] and set the scan conditions.
For details about the scan conditions, refer to [Scan Settings].
4
Load the original, and press Start on the Control panel.
Scanning starts, and the scan data is sent to the selected destination.
in the upper-right of a page, it turns into 
and is registered as a bookmark.