Setting up Job Centro

To use Job Centro, perform the setup in advance.

The setup refers to a series of procedures for connecting the image controller and the computer to the network and installing Job Centro to the computer.

  1. Connect the image controller and the computer to the network.

  2. Check that the computer to be used is connected to the network.

  3. Confirm the IP address and the port number of the JSP settings of the image controller.

  4. Install Job Centro.

Reference
  • For details about the connectable interfaces, refer to Operating environment.

  • For details about the network settings and confirmation of IP address of the image controller, refer to [NIC Settings].