[2-Side Slit]
Overview
Configure settings to slit both edges of paper.
Trimming can be set individually for the top and bottom.
Setting Procedure (Setting [2-Side Slit])
1
On the [2-Side Slit] screen, set the slit amount for 2-Side Slit.
Select [(1)] or [(2)], and use the on-screen keypad or [,]/[+] to enter the numeric value.
[(1)]: Sets the slitting amount at the top of the paper.
[(2)]: Sets the slitting amount at the bottom of paper.
Range: 8.0 mm to 26.0 mm
When the slitting amount is different between [(1)] and [(2)] by 10.0 mm or more, its value cannot be entered.
[Offset against Cover]: You cannot enter a value of which a difference of the slitting amount of [(2)] is greater than or equal to 10.0 mm.
2
Set [Offset against Cover].
Press [Offset against Cover], and use the on-screen keypad or [,]/[+] to enter the numeric value.
Sets the slitting amount of the body for the cover.
Range: -1.0 mm to +1.0 mm
This item is available when [With Cover] is set in the [Booklet] function of [Application].
3
Press [OK].
in the upper-right of a page, it turns into 
and is registered as a bookmark.