[Crease]

Configure the setting to crease only the covers for Multi Half Fold.

NOTICE

• Multi Half Fold sheets are output to the Bundle exit tray. Set the Extension tray of the bundle exit tray as preparation, and open the Stopper. Otherwise, the output paper may drop down from the Bundle exit tray. Also, the full-load detection function of Saddle Stitcher SD-513 may not work.
• When using thin paper that curls easily for Multi Half Fold, output prints so that paper is curled toward the inside. Before outputting a booklet, print out just a few sheets to the Secondary (sub) tray, and check the direction of the curl. If the printed-out sheets are curled upward, the paper is curled inward when a booklet is created.

NOTICE

The following setting is required to use this function.

• Set [Booklet] of [Application] to [With Cover].