Menu

Color

Color Adjustment
- Overview of Color Adjustment
Color Matching: Matching the Target Colors
- About Color Matching
- Executing Color Matching
Color Management: Stabilizing Color Reproducibility
- About Color Management
- Color Management Adjustment Flow
- Image Quality Adjustment Using Image Controller
- Image Quality Adjustment Using Color Centro
Adjusting the Image Quality
- Controller Calibration
- Executing Advanced Controller Calibration (Exact Color)
- Executing Advanced Controller Calibration (G7)
- Registering the Output Profile (Printer Profile)
- Color Validation
- [Spot Color]: Printing in Special Colors
- Registering Alternative Colors (Changing RGB colors to CMYK colors)
- Registering Alternative Colors (Changing CMYK Colors to Different CMYK Colors)
- [Tone Curve]: Adjusting the Brightness and Contrast
- Color Default Settings
- Register a Color Configuration
- Changing the Screen

Executing Color Validation: Printer Driver

You can specify a setting to perform Color Validation just before you print a job.

Use a printer driver, Job Centro, or Hot Folder.

This section describes settings on a printer driver.

In Print Mode of the Workflow tab, select Wait.
Click the Quality tab.
- supplementary explanationFor details, refer to [Quality] Screen.
Select Color Validation.
Click OK.
Color Validation is performed, and then the result is printed.
Check the result, and then press Start on the control panel.
The job is printed.