Sending to a Group
Overview
You can register and send multiple destinations to a group.
Tips
- First set the group in order to send to the group. For details, refer to [Register/Edit] (Group).
Procedure
1
Press [SCAN].
2
Press [Group].
[E-mail] is selected by default. For details about the default display for the [SCAN] screen, refer to [Scan Address Default Setting].
3
Press the registration name in the destination list, and select a group destination.
The selected destination is displayed in [List] of the left pane of the screen.
To cancel the selected destination, press the selected registration name again.
To check the destinations registered in the group, select the desired group, and press [List].
When changing a destination to register in a group, press [Edit] on the [Group Address List] screen.
4
Press [Scan Settings].
The [Scan Settings] screen is displayed.
5
Configure the read (scan) conditions.
For details about the scan conditions, refer to [Scan Settings].
6
Load the original, and press Start on the Control panel.
Press [Address] to return to the [SCAN] screen.
The destination or [Scan Settings] screen settings may not be deselected even after sending. It is recommended that you deselect settings and the destination once the operation is finished. On the [Scan Settings] screen, press Reset on the Control panel to deselect the settings. You can also deselect the destination by pressing [Clear All] on the [SCAN] screen, or by pressing Reset on the Control panel.
in the upper-right of a page, it turns into 
and is registered as a bookmark.