Sending to a Registered FTP Server
Procedure
1
Press [SCAN].
2
Press [FTP].
[E-mail] is selected by default. For details about the default display for the [SCAN] screen, refer to [Scan Address Default Setting].
3
Press the registration name in the destination list, and select a destination.
The selected destination is displayed in [List] of the left pane of the screen.
To cancel the selected destination, press the selected registration name again.
Using the search function allows you to search for a destination. For details about the search function, refer to Searching Addresses.
Pressing [Input Address] allows you to manually enter a destination. For details about how to enter a destination, refer to Sending to an Unregistered FTP Server.
4
Press [Scan Settings].
The [Scan Settings] screen is displayed.
5
Configure the read (scan) conditions.
For details about the scan conditions, refer to [Scan Settings].
6
Load the original, and press Start on the Control panel.
Press [Address] to return to the [SCAN] screen.
The destination or [Scan Settings] screen settings may not be deselected even after sending. It is recommended that you deselect settings and the destination once the operation is finished. On the [Scan Settings] screen, press Reset on the Control panel to deselect the settings. You can also deselect the destination by pressing [Clear All] on the [SCAN] screen, or by pressing Reset on the Control panel.
in the upper-right of a page, it turns into 
and is registered as a bookmark.