Settings on the Receiving End Computer
Required Settings
Scanning using HDD TWAIN drivers requires the following settings to be configured in advance.
Connected to a network via TCP / IP.
The HDD TWAIN driver must be installed.
An application that supports the TWAIN scanner driver must be installed.
Tips
The HDD TWAIN driver is required to import scan data to the computer. The HDD TWAIN driver and the User's Guide that describes the HDD TWAIN driver usage instructions can be downloaded from the following URL.
- https://www.btapac.konicaminolta.com/drivers/utilities/index.html
Scanning using Web Service drivers requires the following settings to be configured in advance.
Connected to a network via TCP / IP.
The system should be installed to your computer as a WSD scan device.
Procedure (Installing as a WSD Scan Device)
1
Check that [Network discovery] has been enabled.
[Network discovery] can be checked by clicking [Network and Sharing Center] in [Control Panel], and then [Change advanced sharing settings].
2
Open the [Devices and Printers] screen.
To access the [Devices and Printers] screen, select [Hardware and Sound] from [Control Panel].
3
Check that the system's scan icon is displayed.
The installation is complete once the icon is displayed.
Go to Step 4 if the icon is not displayed.
4
Click [Add a device] from the menu.
The [User Account Control] screen may display. Check the contents before continuing.
5
Select the system's scanner, and click [Next].
6
The driver software is installed.
in the upper-right of a page, it turns into 
and is registered as a bookmark.