Adjust the center position at two locations on the rear edge for 4-position staple in Saddle Stitcher SD-513.
Objects of Adjustment: Offset for All Size, B4 , 8K , 11 17 , A3 , Custom (380 to 488 mm), Custom (257 to 379 mm)
If a numeric value is specified for [Offset for All Size], it is applied to all paper sizes. With a specific paper size selected,the set value becomes the sum of the entered value and the value previously specified for [Offset for All Size].
Make this adjustment after completing [Half-Fold Position Adj.].
Press [Adjustment] on the [MACHINE] screen to display the [Adjustment Menu] screen.
Press [Finisher Adjustment], [Saddle Stitcher Adjustment], [Staple Center Position], and [4 Position Staple(Rear 2)] in sequence.
Select the size to be adjusted.
Press [Print Mode].
Load the paper with the size to be adjusted, then select that tray.
Press Start on the control panel.
A sample pattern will be output.
For the paper size, check the length from the edge to the center at two locations on the rear edge for 4-position staple.
If any adjustment is required, press [Exit PrintMode] to return to the [Staple Center Position Adjustment] screen.
Use the touch panel keypad to enter the set value.
Use [+/-] to specify the value to be positive or negative.
Press [Set] to change the Current Value.
Adjustment Range: 100 ([To move rearward]) to 100 ([To move frontward]) (1 step = 0.1 mm)
Repeat steps 4 to 9 until the desired result is obtained.
Press [Return].
The screen returns to the [Staple Center Position Adjustment Menu] screen.