Home Settings and AdjustmentsFold & Staple Stopper: Adjusting the Position of Staples (Only for Finisher FS-612)

Fold & Staple Stopper: Adjusting the Position of Staples (Only for Finisher FS-612)

When using Finisher FS-612, adjust the Fold&Staple staple position.

Objects of Adjustment: Offset for All Size, A3 , B4 , SRA4 , A4 , 12 18 , 11 17 , 8.5 14 , 8.5 11 , 8 13 , 8K , 16K , SRA3 , Custom (380 to 458 mm), Custom (279 to 379 mm)

  1. Press [Adjustment] on the [MACHINE] screen to display the [Adjustment Menu] screen.

  2. Press [Finisher Adjustment] and [Fold & Staple Stopper] in sequence.

  3. Select the size to be adjusted using [] or [].

  4. Press [Print Mode].

  5. Load the paper with the size to be adjusted, then select that tray.

  6. Press Start on the control panel.

    A sample pattern will be output.

  7. Measure the difference (a) between the center line and the position of staples.

    Allowance: a = 0 mm ± 1 mm

  8. If any adjustment is required, press [Exit PrintMode] to return to the [Fold & Staple Stopper Adjustment] screen.

  9. Use the touch panel keypad to enter the set value.

    • Use [+/-] to specify the value to be positive or negative.

    • Press [Set] to change the current value.

    • Adjustment Range: -128 ([To move to the right]) to +127 ([To move to the left]) (1 step = 0.1 mm)

  10. Repeat steps 4 to 9 until the desired result is obtained.

  11. Press [Return].

    The screen returns to the [Finisher Adjustment Menu] screen.