Adjust the distance from the edge of the printed paper to the centers of punch holes, when using Punch Kit PK-512 or Punch Kit PK-513 mounted on Finisher FS-531 or Finisher FS-612.
Objects of Adjustment: PI Tray, Main Body Tray
Press [Adjustment] on the [MACHINE] screen to display the [Adjustment Menu] screen.
Press [Finisher Adjustment], [Punch Adjustment], and [Horizontal Position Adj.] in sequence.
Select either [PI Tray] or [Main Body Tray].
Press [Print Mode].
Select the tray loaded with paper.
Press Start on the control panel.
A sample pattern will be output.
Measure the distance (a) from the edge of the printed paper to the centers of punch holes.
Allowance: a = 10.5 mm ± 5.0 mm
If any adjustment is required, press [Exit PrintMode] to return to the [Horizontal Position Adjustment] screen.
Use the touch panel keypad to enter the set value.
Use [+/-] to specify the value to be positive or negative.
Press [Set] to change the current value.
Adjustment Range: -50 ([To shorten]) to +50 ([To extend]) (1 step = 0.1 mm)
Repeat steps 4 to 9 until the desired result is obtained.
Press [Return].
The screen returns to the [Punch Adjustment Menu] screen.