Adjust the center position for 2-position staple in Saddle Stitcher SD-513.
Make this adjustment after completing [Half-Fold Position Adj.].
Press [Adjustment] on the [MACHINE] screen to display the [Adjustment Menu] screen.
Press [Finisher Adjustment], [Saddle Stitcher Adjustment], [Staple Center Position], and [2 Position Staple] in sequence.
Press [Print Mode].
Load A3 paper or 11 17 paper into any tray, then select its tray button.
Press Start on the control panel.
A sample pattern will be output.
Check the misalignment between the staple center position and paper center position.
If any adjustment is required, press [Exit PrintMode] to return to the [Staple Center Position Adjustment] screen.
Use the touch panel keypad to enter the set value.
Use [+/-] to specify the value to be positive or negative.
Press [Set] to change the Current Value.
Adjustment Range: -20 ([To move closer to rear edge]) to +20 ([To move closer to front edge]) (1 step = 0.1 mm)
Repeat steps 3 to 8 until the desired result is obtained.
Press [Return].
The screen returns to the [Staple Center Position Adjustment Menu] screen.