Adjust the position of the exit guides in the crosswise direction of the Relay Unit RU-510. If any punch holes are misaligned in the crosswise direction, make this adjustment.
Objects of Adjustment: Offset for All Size
Press [Adjustment] on the [MACHINE] screen to display the [Adjustment Menu] screen.
Press [Finisher Adjustment], [Relay Stacker Adjustment], and [Paper Width Adjustment] in sequence.
Press [Print Mode].
Load A4 paper in a tray, and select that tray.
Set the print quantity to 10, then press Start on the control panel.
A punched sample pattern is printed.
Check for any misalignment or inconsistency of punch holes in the crosswise direction.
Press [Exit PrintMode].
The screen returns to the [Paper Width Adjustment] screen.
If any adjustment is required, use the touch panel keypad to enter the set value.
Adjustment Range: -20 ([To reduce the randomness]) to +20 ([To reduce the tilts]) (1 step = 0.1 mm)
Use [+/-] to specify the value to be positive or negative.
Press [Set] to change the setting with the Current Data.
Repeat steps 3 to 9 until the desired result is obtained.
Press [Return].
The screen returns to the [Relay Stacker Adjustment Menu] screen.