Home Settings and AdjustmentsParallel Trimming Adjustment: Adjusting the Levelness between the Trimming Line and Cut Edge

Parallel Trimming Adjustment: Adjusting the Levelness between the Trimming Line and Cut Edge

Adjust the levelness between the trimming line and cut edge in Saddle Stitcher SD-513.

Objects of Adjustment: Front, rear

  • This adjustment is available only when Saddle Stitcher SD-513 is equipped with Folding Unit FD-504.

  1. Press [Adjustment] on the [MACHINE] screen to display the [Adjustment Menu] screen.

  2. Press [Finisher Adjustment], [Saddle Stitcher Adjustment], and [Parallel Trimming Adjustment] in sequence.

  3. Select [Front] or [Rear].

  4. Press [Print Mode].

  5. Load A3 paper or 11 17 paper into any tray, then select its tray button.

  6. Press Start on the control panel.

    A sample pattern will be output.

  7. Measure levelness a of the trimming edge.

    Allowance: a = 4.0 mm or less (when 50 sheets are folded and stapled in Fold & Staple)

  8. If any adjustment is required, press [Exit PrintMode] to return to the [Trimming Levelness Adjustment] screen.

  9. Use the touch panel keypad to enter the set value.

    • Press [Set] to change the Current Value.

    • Adjustment Range: -0 ([To narrow]) to +30 ([To widen]) (1 step = 0.1 mm)

  10. Repeat steps 4 to 9 until the desired result is obtained.

  11. Press [Return].

    The screen returns to the [Saddle Stitcher Adjustment Menu] screen.