Home Settings and AdjustmentsOutputting the Density Balance Chart

Outputting the Density Balance Chart

There are two types of spectrophotometers to read the chart.

  • i1-iSisXL

  • Output a chart to which the screen type that has been set by the machine was applied.

    Before outputting the chart, an appropriate screen and paper must be selected.

  • [Stochastic], however, cannot be selected to output a chart.

  1. Follow the procedure on Administrator Setting to display the [Administrator Setting Menu] screen.

  2. Press [System Setting] on the [Administrator Setting Menu] screen, and then press [Expert Adjustment], [Quality Adjustment], [Density Balance Adjustment], and [Density Balance Chart Output] in sequence.

  3. Select the desired spectrophotometer, and press [Print Mode].

  4. Press [Quality Adj.].

  5. Press [] on the right side of [Screen Pattern] to display the desired screen.

    • If necessary, you can press [Screen Pattern] to display the [Screen Pattern] screen and select any screen. Select a screen, and press [OK].

    • Press [Close] on the [Quality Adjustment] screen.

  6. Select a paper size for the chart.

    • Load 12 18 , SRA3 , 11 17 , or A3 paper in a tray, then select that tray.

  7. Press Start on the control panel.

    A test chart is printed.

  8. Press [Exit PrintMode].

    The screen returns to the [Density Balance Chart Output] screen.

  9. Press [Return].

    The screen returns to the [Density Balance Adjustment Menu] screen.