Function Overview
- Function Overview
- Adjustment Menu
  - Adjustment Items
Quality Adjustment
Machine Adjustment
- Printer Adjustment
- Scan Adjustment
Stabilization Adj. Setting
Execute Adjust Operation
Finisher Adjustment
- Staple Finisher(Main) Adj. (Finisher FS-532)
- Staple Finisher(Fold) Adj. (Finisher FS-532)
- Staple Finisher(Punch) Adj. (Finisher FS-532)
- Staple Finisher(PI) Adj. (Finisher FS-532)
  - PI Registration Adjustment
- Staple Finisher(Main) Adj. (Output Tray OT-510)
- Multi Folder(Punch) Adj. (Folding Unit FD-503)
  - Paper Width Adjustment
  - Punch Vertical Position Adj.
- Multi Folder(Fold) Adj. (Folding Unit FD-503)
- Stacker Adjustment (Large Capacity Stacker LS-506)
  - Paper Width Adjustment
  - Paper Length Adjustment
- Saddle Stitcher Adjustment (Saddle Stitcher SD-506)
- Saddle Stitcher Adjustment (Saddle Stitcher SD-513)
- Perfect Binder Adjustment (Perfect Binder PB-503)
- Finisher Adjustment (Finisher FS-531 / Finisher FS-612)
- Relay Stacker Adjustment (Relay Unit RU-510)
  - Paper Width Adjustment
  - Paper Length Adjustment
ADF Adjustment
PFU Air Assist Adjustment
IQ Detected Result
IQ Function Setting
Memory Status
Both Sides Adjust
Adjusting the Finishing
- Image Quality
- Adjusting the Margin between Pages
  - About Book Spread Printing
  - Gutter Adjustment
- Adjusting the Staple Positions
- Adjusting Misalignment or Tilt of the Punch Hole Positions
- Adjusting the Half-Fold Position of a Booklet
- Adjusting Misalignment, Skew, and Protrusion of a Perfect-Bound Book
- Adjusting the Folding Positions

2-Side Slitting Adjustment

Adjust the 2-side slitting amount of Trimmer Unit TU-503 mounted on Saddle Stitcher SD-513.

Adjustment range: Front, Rear

Press Adjustment on the MACHINE screen to display the Adjustment Menu screen.
Press Finisher Adjustment, Saddle Stitcher Adjustment, and 2-Side Slitting Adjustment in sequence.
Select Front or Rear.
Press Print Mode.
Load A3 paper short edge feed or 11 17 short edge feed paper in any tray, and select the button of that tray.
Press Start on the control panel.
A sample pattern will be output.
Measure the length of output paper, "a", then check the difference between the measurement value and the set value.
Allowance: Setting value-a = within ±0.5 mm
If any adjustment is required, press Exit PrintMode to return to the 2-Side Slitting Adjustment screen.
Use the touch panel keypad to enter the set value.
Adj. Range: -10~+10 1 step = 0.1 mm
[-] To narrow [+] To widen
- supplementary explanationUse +/- to specify the value to be positive or negative.
- supplementary explanationPress Set to change the Current Value.
Repeat steps 4 to 9 until the desired result is obtained.
Press Return.
The screen returns to the Saddle Stitcher Adjustment Menu screen.