PFU Air Assist Adjustment

There are air nozzles on the apical part of the feeder and the side guides of each tray in Paper Feed Unit PF-707m. Air blown from the nozzles makes feeding go smoothly by handling papers.

Depending on the paper type, smooth feeding may be difficult, and it may cause a paper jam. In this case, manually change the air assist settings. You can manually adjust the settings while checking the condition of air blow in the tray by shining a light from the air nozzle confirmation window of the tray.

NOTICE

  • PFU Air Assist Adjustment is not displayed by default. To use this setting, please contact your service representative.

  • Tray 3, Tray 6, and Tray 9 cannot be checked from the air nozzle confirmation window. Manually configure the Air Assist settings for a tray other than Tray 3, Tray 6, and Tray 9, then set the same adjustment value for Tray 1, Tray 4, and Tray 7.

  1. Press Adjustment on the MACHINE screen to display the Adjustment Menu screen.

  2. Press PFU Air Assist Adjustment.

  3. Select a target tray.

  4. Select Auto or Manual in Setting Method.

    • supplementary explanationWhen selecting Auto, Lead Edge Air Level Setting and Side Air Level Setting is set automatically depending on paper size, paper type, and paper weight.

  5. Press Start.

    Air starts blowing.

    • supplementary explanationWhen selecting Auto in step 4, and then check the air level and go to step 8.

    • supplementary explanationWhen selecting Manual in step 4, and then go to step 6.

  6. Adjust Lead Edge Air Level Setting.

    • supplementary explanationAdjust while confirming the amount of paper float from the air nozzle confirmation window.

    • supplementary explanationAdj. Range: (Weak) 1 to 9 (Strong)

    • supplementary explanationWhen pressing Weak, the air blow of the lead edge becomes weak and it may improve the feeding for thin paper. When pressing Strong, the air blow of the lead edge becomes strong and it may improve the feeding for thick paper.

  7. Adjust Side Air Level Setting.

    • supplementary explanationAdjust while confirming the amount of paper float from the air nozzle confirmation window.

    • supplementary explanationAdj. Range: OFF, (Weak) 1 to 9 (Strong)

    • supplementary explanationWhen pressing Weak, the air blow of the side becomes weak and it may improve the feeding for thin paper. When pressing Strong, the air blow of the side becomes strong and it may improve the feeding for thick paper. Select OFF to turn off the air blow of the side.

  8. Press Stop.

    Air stops blowing.

  9. Press Print Mode.

    • supplementary explanationThe tray to be adjusted is automatically selected.

  10. Press Start on the control panel.

    • supplementary explanationConfirm the condition of the paper feeding from the air nozzle confirmation window.

  11. Press Exit PrintMode.

  12. Repeat steps 4 to 11 until the desired result is obtained.

  13. Press Close.

    The screen returns to the Adjustment Menu screen.