This system provides the chart used to adjust [Deformation].
To make adjustments, measure the measurement points of the output chart using a scale, and then enter the measurement value.
This adjustment is useful for 2-sided printing with a new paper type, or when the amount of misalignment between both sides is unknown after changing the paper in the paper tray, because the position of both sides can be adjusted by just entering measurement values.
The [Chart Adjustment/Back] screen is displayed.
A chart is output.
The figure shows an example where [1] is measured. The scale resolution is 0.5 mm.
The black "" in the figure indicates the front side, and the blue "" indicates the back side.
You can enter units of up to 0.1 mm.
The figure in step 4 shows the "" of [1] misaligned with the front side by 2.0 mm on the plus side of the X-axis, and by 1.5 mm on the minus side of the Y-axis. In this case, for [1], you want to move the blue line of the back side by 2.0 mm in the minus direction on the X-axis, and by 1.5 mm in the plus direction on the Y-axis. This can be compensated for by entering 20 for X and pressing [+ / -], and entering 15 for Y.