Adjustment Workflow for Each Job
Overview
For jobs in which both-side accuracy is important, or for jobs with high coverage, use the procedure detailed below to adjust the image position if you want to improve both-side accuracy. Perform the adjustment just before you output the job.
When Mounted With Intelligent Quality Care Unit IQ-501
Step 1
Enable [Auto Duplex Adjustment] (Setting Procedure (Performing [Auto Duplex Adjustment]))
After enabling [Auto Duplex Adjustment], select the specific sheet for which you want to improve the both-side accuracy, and output the job. Crop marks are added to the 1st sheet, and the adjustment values for both sides are updated.
Step 2
Disable [Auto Duplex Adjustment] (Setting Procedure (Performing [Auto Duplex Adjustment]))
After disabling [Auto Duplex Adjustment], output the job.
Tips
Turn OFF the following settings before performing Step 2. If they are set to ON, the adjustment values for both sides that were updated in Step 1 may be overwritten. If there are sheets for which the coverage differs greatly from the sheets output as part of the job in Step 1, the front and back sides may not match up.
- [Period. Both Sides Auto Adj.]
- [Concurrent Execution of BothSidesAdj.]
- Auto Image Adjustment
Reference
- For details about [Period. Both Sides Auto Adj.], refer to [Periodical Both Sides Adj.].
- For details about [Concurrent Execution of BothSidesAdj.], refer to [Basic Setting].
- For details about Auto Image Adjustment, refer to To Perform Auto Image Adjustment.
Without Intelligent Quality Care Unit IQ-501
Step 1
Adjust the image position and magnification of the backside.
in the upper-right of a page, it turns into 
and is registered as a bookmark.