About Advanced [Controller Calibration]

Whereas normal calibration adjusts the output density of each color (CMYK) gradation, advanced calibration corrects color tones that could only be handled by recreating the profiles using methods other than density correction for each color (CMYK).

There are 2 ways to perform advanced calibration.

Perform at the following timings.

In order to ensure color stability, make the following image quality adjustments when the screen changes and when the paper type changes, or when color is particularly important.

Even after performing the adjustments, if the color remains unstable, a profile may be created to resolve this issue.

Make other image quality adjustments as needed.

Perform advanced controller calibration using [Exact Color] on the Touch panel.

For details about the procedure, refer to [Exact Color].

NOTICE

• The optional Intelligent Quality Care Unit IQ-501 is required to use this function.

Perform advanced [Controller Calibration] using [G7] on the Touch panel.

For details about the procedure, refer to [G7 Calibration].

NOTICE

• The optional Intelligent Quality Care Unit IQ-501 is required to use this function.

NOTICE

• [Exact Color] is set by default. Contact your relevant service center when switching to [G7 Calibration].

Tips

When switching to G7 calibration, note the following points:

• The conversion table (LUT) and profile created in Exact Color cannot be shared.
• The profile and conversion table (LUT) below are not automatically deleted from the Image Controller. Delete manually.
  - Custom profiles registered before switching
  - Conversion tables (LUT) registered before switching
• The following data can continue to be used when using G7 calibration in an environment other than Color Centro.
  - User data profiles
  - User data spot color tables
• Hold Jobs stored before switching to G7 calibration need to be re-RIPed (color converted) after configuring a suitable profile. After switching, confirm the hold job.