[(2)Cover 2-Side Slit]
Overview
Configure the setting to slit both edges of the cover.
NOTICE
The following setting is required to use this function.
- Set [Cover Print] to [ON].
Setting Procedure
Set [Slitting] for 2-Side Slit.
1
Press [ON].
The setting screen is displayed.
2
Select [(1)] or [(2)] of [Slitting], and use the on-screen keypad to enter the slitting amount.
Range: 8.0 mm to 26.0 mm
Pressing [,]/[+] increases or decreases the numeric value in steps of 0.1 mm.
Use [+ / -] to set the plus or minus of the numeric value.
When the slitting amount is different between [(1)] and [(2)] by 10.0 mm or more, its value cannot be entered.
[Offset against Cover] is not available.
3
Press [OK].
in the upper-right of a page, it turns into 
and is registered as a bookmark.