Roll Winder RW-201

1

EMERGENCY STOP

Press to stop this system in case of emergency. Use only in case of emergency. Pressing EMERGENCY STOP stops the machine immediately. To reset that emergency stop status, press EMG.RESET and also turn EMERGENCY STOP to the right. Do not press EMERGENCY STOP to stop usual printing. It may result the machine and media being damaged.

2

EMG.RESET

When this system stops immediately, clear the error and confirm that the top cover is closed, and then press EMG.RESET to reset the emergency stop.

3

REWIND MOTOR ON

When REWIND MOTOR ON is turned off, the machine does not start printing. Press REWIND MOTOR ON and light REWIND MOTOR ON to start printing.

4

REWIND MOTOR OFF

Turn off REWIND MOTOR ON when printing ends.

5

STOP

Stops jobs while conveying a paper and printing. Stops the whole system.

• The LED lights up in the emergency stop status.

• When Roll Winder RW-201 is stopped, the LED blinks.

• Press STOP while the LED flickers, the LED turns off and the stop status is canceled.

6

READY

Rotate the winding shaft of Roll Winder RW-201 alone and convey the media. If READY is pressed while the machine is stopped and offline, the alarm beeps for three seconds. For five seconds after the time the alarm stops, JOG is effective.

7

JOG

When the machine is stopped and offline, you can operate the conveyer of Roll Winder RW-201 for five seconds from the time READY is pressed and the alarm stops beeping. While pressing JOG, the conveyer operates. Use the function when adjusting the media.

If JOG is not pressed within five seconds, or STOP is pressed, newly press READY.