[Change User]

Configure the setting to reset job conditions when the system’s user is changed.

If the following operations are performed, this system determines that the user was changed.

• Removing the key counter or copy card

• Pressing Access on the Control panel after authentication was acquired

[ADF Original Direction]

Configure the setting to reset copy or scan conditions when loading the original on the ADF.

[Reset Button Function]

[Initialize]

Returns to the optionally specified copy, scan, or store conditions when this system is reset.

[Full Auto]

Returns to the factory setting when this system is reset. However, [Finisher Mode when Full Auto] can be changed optionally.

[Mode Memory Auto Call]^*1

[ON]

Calls the condition registered in each program No. 30 when this system is reset.

[OFF]

Calls [Initial Setting] of [User Setting] when this system is reset.

[Finisher Mode when Full Auto]^*2

Select the post-processing setting for output when this system is reset. Selects the default setting of the finisher.

[Initial by KeyCounter Insert]

Set whether to reset this system when the key counter or copy card is inserted.

[Status Hold When Auto Reset]

[Not Keep]

Returns to the initial state without maintaining the status Original glass and ADF when this system is reset.

[Keep]

Maintains the unreset status of Original glass and ADF when this system is reset.

[Next Job Staple Setting]

Configure the setting to release the Staple mode when a copy job is completed in Staple Sort.

If [Release] is selected, the sort mode is set.

[Original Set/Bind Direction]

Configure the setting to maintain the following settings without releasing them for each job.

• [Direction] of [Original Setting]

• [Bind Direction] of [Output Setting]

If [Release] is set, the setting is released for each job.