[Crease]

This is a function that creases the copied paper to make it easier to fold.

You can set the number of creases and their positions. Select the down convex side of creases from the front side or back side.

The available crease positions vary depending on the paper length (length of the long side).

This section describes Saddle Stitcher SD-513.

NOTICE

The following option is required to use this function.

• Saddle Stitcher SD-513 with Creaser Unit CR-101 mounted

Set [The Number of Creases], [Crease Side], and [Crease Position].

[The Number of Creases]: Set the number of creases between 1 and 4 creases.

The available crease positions vary depending on the paper length (length of the long side).

Tips

The number of creases may be limited as follows depending on the combined copy conditions.

• When [Fold&Staple] or [Multi Half] is selected, only 1 crease can be selected for a cover. The body cannot be creased. For details, refer to [Fold&Staple] or [Multi Half].
• When [Multi 3-Fold] is selected, only 2 creases can be applied to the paper to be folded in thirds. For details, refer to [Multi 3-Fold].
• When [Perfect Bind] is selected, 2 or 4 creases can be selected for a cover. The body cannot be creased. For details, refer to [Perfect Bind].

[Crease Side]	Description
[Front]	Makes creases on the front side.
[Back]	Makes creases on the back side.

[Crease Position]: Set the position to crease the paper.

The available crease positions vary depending on the paper length (length of the long side) and [The Number of Creases].

[The Number of Creases]	[Crease Position]	Illustration
[1 Piece]	[(1)] Paper length La: 7 mm to (La - 46) mm Paper length Lb: (Lb - 330) mm to 290 mm
[2 Pieces]	[(2)] Paper length La: ([(1)] position +1.0) mm to (La - 46) mm Paper length Lb: ([(1)] position +1.0) mm to 290 mm
[3 Pieces]	[(3)] Paper length La: ([(2)] position +1.0) mm to (La - 46) mm Paper length Lb: ([(2)] position +1.0) mm to 290 mm
[4 Pieces]	[(4)] Paper length La: ([(3)] position +1.0) mm to (La - 46) mm Paper length Lb: ([(3)] position +1.0) mm to 290 mm

1

Set [The Number of Creases].

• Set the number of creases between 1 and 4 creases.

2

Set [Crease Side].

• Set the front side or back side.

3

Set [Crease Position].

• Select the position in [(4)] from [(1)], and use the on-screen keypad or [,]/[+] to enter the numeric value.

4

Press [OK].